Transcript: Hey everybody, this is AJ with Earlbeck Gases & Technologies coming to ya from York, Pennsylvania at our welder training and certification center! Today we are going over the Fronius Accupocket 150; it is a battery-operated STICK/TIG welder. This welder is 150 amps and RUNS OFF OF BATTERY POWER! STICK System includes: Electrode holder, ground clamp, charger and case! This welder will get about 19-20 3/32 rods on a single charge and about 132” of TIG welding. The system that we have set up today is just the STICK set up. ***They do make one for TIG welding*** TIG setup includes gas solenoid in the back, welder, flow meter, stick and ground clamp as well. This machine produces true DC current! From a welder’s standpoint, it’s not like welding with anything else - plug it in and go! You can definitely tell a difference in the way that the rod flows as you are welding. It is lightweight and only 25 lbs and easy to take on/off the job. Great for mechanical contractors, steel erectors, handrail and farm repairs. It is durable and only takes 30 mins to charge – kill the battery, plug it in and after 30 mins you are ready to weld! It sure does beat pulling 100 ft weld lead and ground cable just to do a 15-minute job. If you have any questions or would like a demo, feel free to give us a call at any of our locations below: Baltimore, MD (410) 687-8400 York, PA (717) 916-6611 Belstville, MD (301) 937-8884 Moosic, PA (570) 457-8954 |